COMPONENT DESIGN FOR ASSEMBLY
After the final concept presentation, MWDesign will focus on the approved product concept. This will be done primarily through 3D CAD modelling. We will further development the CAD models into precise components incorporating all features from the final concept design. The objective is to develop the design to allow us to create a prototype for testing, before investing in tooling.
Focusing on individual part components, MWDesign will refine the components and design out the cost to enable us to maintain quality while meeting our budget cost. We will begin engineering the parts for the product, focusing on functional aspects of the design.
COMPONENT DESIGN FOR ASSEMBLY
After the final concept presentation, MWDesign will focus on the approved product concept. This will be done primarily through 3D CAD modelling. We will further development the CAD models into precise components incorporating all features from the final concept design. The objective is to develop the design to allow us to create a prototype for testing, before investing in tooling.
Focusing on individual part components, MWDesign will refine the components and design out the cost to enable us to maintain quality while meeting our budget cost. We will begin engineering the parts for the product, focusing on functional aspects of the design.
COMPONENT DESIGN FOR ASSEMBLY
After the final concept presentation, MWDesign will focus on the approved product concept. This will be done primarily through 3D CAD modelling. We will further development the CAD models into precise components incorporating all features from the final concept design. The objective is to develop the design to allow us to create a prototype for testing, before investing in tooling.
Focusing on individual part components, MWDesign will refine the components and design out the cost to enable us to maintain quality while meeting our budget cost. We will begin engineering the parts for the product, focusing on functional aspects of the design.
AIR NZ Q300
New livery painting masks.
The task was to create painting masks for the new Air New Zealand livery for the Q300 aircraft.
Distorted shapes created on 3D CAD surfaces needed to be cut from paper and applied to the actual Q300 aircraft as painting masks.
As 3D surface models were not available, we created the surfaces from blueprints. Having the surfaces, we projected the new livery onto the plane. The painting masks were then unwrapped from the surface allowing the distorted shapes to be cut from paper and applied to the actual Q300 aircraft for painting.
New livery as viewed from different angles on the CAD surfaces.
